The ES1222-A board is designed for powerful rapid prototyping as well as for high performance measurement and calibration applications. The intelligent interface board ES1222.4-A can be used to connect one or more control units to an ES1000 system via the CAN interfaces and/or the K-Line interface. This permits the plug-in card to be used for the following applications:
- Control unit calibration via CAN bus and/or diagnostic interface
- Recording of communication data in one or more CAN networks
- Simulation of CAN nodes in CAN networks
- Flash programming of control units
- Control unit diagnostics
- Connection of external devices to VME bus systems via the CAN interface
- Measurement of environmental data, e.g., via IPETRONIK modules
Functions at a Glance
- CAN Interface
- 4 independent, electrically isolated CAN channels
- ISO-highspeed physical layer
- Max. 1 MBaud transmission rate
- CAN protocol V2.0a/V2.0b (standard/extended identifier)
- Protocols for measurement and calibration: CAN Calibration
- Protocol V2.0/V2.1 (standardized ASAP1b CCP), KWP2000 on CAN, XCP on CAN, UDS on CAN (ISO 14229/ISO 15765)
- K-Line Interface
- Electrically isolated from VME bus
- Diagnostic testers compliant with ISO 9141-2
- Max. 250 kBaud transmission rate
- Protocols: McMess, KWP2000, Keyword71
- Cables protected from signal interference by individually shielded channels
- Firmware update of the ES1222.4-A possible via PC using service software
- Integrated with ASCET-RP, INTECRIO, and INCA