You are cordially invited to Automotive Engineering Exposition 2010, May 19-21, 2010, at the Pacifico Yokohama Exhibition Hall - Yokohama.

04/26/2010

ETAS Japan participates in the Automotive Engineering Exposition 2010

You are cordially invited to Automotive Engineering Exposition 2010, May 19-21, 2010, at the Pacifico Yokohama Exhibition Hall - Yokohama.
Find out about the latest ETAS tools and solutions for development, testing,  and measurement & calibration of automotive embedded software by visiting us at booth 89.

At the show, we will demonstrate solutions for automotive embedded software development.

  • HEV/EV development solution:
    Demo: Simulation for Motor & Battery ECU Development.
    New products for HEV/EV can implement high-speed measurement, high-speed calculation.
    XETK, INCA, EHOOKS, LABCAR-RTPC, LABCAR-OPERATOR, ES592, ES400 series for high voltage measurement, ES910
  • Vehicle system verification solution:
    Demo: ETAS' new ES720 drive recorder (to be released this autumn) for verification of the total vehicle system. How to calculate EGR with ES635/ES636, cost-efficient measurement device. etc.
    ES720, ES593, ES636, ES413, ES421, XETK
  • Quality and cost efficiency improvement in measurement and calibration process:
    Demo: INCA V7.0 (to be released this autumn) new function features, calibration process automation tool CaliAV® etc.
    INCA V7.0, CaliAV®, INCA-SIP

Technical Conference Information
New Products, New Technology - Introduction Seminar
Measurement & Calibration Solution for HEV/EV ECU Development - Multi Node Time-synchronous Measurement
Speaker: ETAS K.K. Marketing Dept. Technical Expert Tadaaki Sato
Location: Pacifico Yokohama/New Products,  New Technology Introduction Seminar (first conference room)
Friday, May 21, 1:15– 1:45 p.m.
Capacity: 120